Slow Down If Layer Print Time Is Below
< SETTINGS | Filament | Cooling | Cooling Thresholds(Redirected from Settings/Filament/Cooling/Cooling Thresholds/Slow Down If Layer Print Time Is Below)|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The minimum amount of time a layer must take to print. If a layer will take less than this amount of time, the movement speed is reduced so the layer print time will match this value, down to the minimum print speed at the slowest.
Parameters
- seconds
Example(s)
seconds
In this example, if a layer will take less than 40 seconds to print, print speed will be slowed to attempt to have the layer take this long to print.
