Changes

Jump to: navigation, search

SETTINGS/Filament/Extrusion/Flow/Extrusion Multiplier

45 bytes removed, 00:08, 16 January 2016
no edit summary
This value can also be adjusted during a print using the [[Controls/Tuning Adjustment#Extrusion Multiplier|Extrusion Multiplier]] slider on the Controls pane. Keep in mind using the function in Controls will have an effect in addition to any existing multiplier used in the setting described on this page. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08).
=== Range Formula ===
All extrusions are multiplied by this value. Increasing it above 1 The general extrusion flow formula: <code>layer height / (1.1 is a good max value) will increase the amount of filament being extruded; decreasing it area (.9 is a good minimum valuepi*r²) * '''extrusion multiplier''') will decrease the amount being extruded.</code>|*multiplier
=== Formula Range ===
The general extrusion flow formula: <code>layer height / Increasing it above 1 (1.1 is a good max value) will increase the amount of filament area being extruded; decreasing it (pi*r²) * '''extrusion multiplier'''.9 is a good minimum value)</code>|*multiplierwill decrease the amount being extruded.|
=== multiplier ===
In this example, all extrusions will be multiplied by 1.04.}}
Retrieved from "http://wiki.mattercontrol.com/Special:MobileDiff/1505"

Navigation menu