View source for SETTINGS/General/Layers-Surface/Layer Height/First Layer Height

{{Migrated|slice-settings/general/general#first-layer-thickness}}
{{Slice Settings

|The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.|*millimeters (mm) 
*percent [of [[Settings/General/Layers-Surface/Layer Height/Layer Height|Layer Height]]] (%)|

=== mm ===

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.}}

=== % ===

Must enter '%' after input to activate. Used to specify height of first layer relative to [[Settings/General/Layers-Surface/Layer Height/Layer Height|Layer Height]] as a percentage.

[[File:{{SUBPAGENAME}}-ss-ex1.png]]