SETTINGS/Printer/Custom G-Code/After Tool Change G-Code - Revision history

MatterHackers: MatterHackers moved page Settings/Printer/Custom G-Code/After Tool Change G-Code to SETTINGS/Printer/Custom G-Code/After Tool Change G-Code

2016-12-01T20:37:48Z

MatterHackers moved page Settings/Printer/Custom G-Code/After Tool Change G-Code to SETTINGS/Printer/Custom G-Code/After Tool Change G-Code

MatterHackers: MatterHackers moved page Settings/Printer/Custom G-Code/Tool Change G-Code to Settings/Printer/Custom G-Code/After Tool Change G-Code without leaving a redirect

2016-11-15T20:37:08Z

MatterHackers moved page Settings/Printer/Custom G-Code/Tool Change G-Code to Settings/Printer/Custom G-Code/After Tool Change G-Code without leaving a redirect

MatterHackers at 17:27, 12 October 2016

2016-10-12T17:27:45Z

MatterHackers at 17:52, 17 February 2016

2016-02-17T17:52:27Z

MatterHackers: MatterHackers moved page Slice Settings/Printer/Custom G-Code/Tool Change G-Code to Settings/Printer/Custom G-Code/Tool Change G-Code without leaving a redirect

2016-01-20T20:56:15Z

MatterHackers moved page Slice Settings/Printer/Custom G-Code/Tool Change G-Code to Settings/Printer/Custom G-Code/Tool Change G-Code without leaving a redirect

MatterHackers: Created page with "{{Slice Settings |G-Code to be run after every tool change (T0, T1, T2, etc.).|*G-Code Will accept Custom G-Code variables.| === G-Code === In..."

2016-01-13T21:41:47Z

Created page with "{{Slice Settings |G-Code to be run after every tool change (T0, T1, T2, etc.).|*G-Code Will accept Custom G-Code variables.| === G-Code === In..."

New page

{{Slice Settings

|G-Code to be run after every tool change (T0, T1, T2, etc.).|*G-Code

Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|

=== G-Code ===

In this example, the printer will run a series of G-Code commands to wipe the nozzle after every T0, T1, T2, etc. during the print.}}

← Older revision	Revision as of 20:37, 1 December 2016
(No difference)

← Older revision	Revision as of 20:37, 15 November 2016
(No difference)

@@ Line 1: / Line 1: @@
 {{Slice Settings
-|G-Code to be run after every tool change (T0, T1, T2, etc.).|*G-Code
+|G-Code to be run after every tool change (T0, T1, T2, etc.).
 *[[Custom_G-Code_Variables|Custom G-Code variables]]

@@ Line 2: / Line 2: @@
 |G-Code to be run after every tool change (T0, T1, T2, etc.).|*G-Code
-Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|
+All G-Code must be uppercase to function properly.|
 === G-Code ===
 In this example, the printer will run a series of G-Code commands to wipe the nozzle after every T0, T1, T2, etc. during the print.}}

← Older revision	Revision as of 20:56, 20 January 2016
(No difference)