SETTINGS/Printer/Custom G-Code/Start G-Code - Revision history

MatterHackers: MatterHackers moved page Settings/Printer/Custom G-Code/Start G-Code to SETTINGS/Printer/Custom G-Code/Start G-Code

2016-12-01T20:37:49Z

2016-10-12T17:27:42Z

2016-02-17T17:51:34Z

2016-02-03T00:58:40Z

2016-01-21T01:09:23Z

2016-01-20T20:56:15Z

2016-01-13T21:28:34Z

2016-01-05T23:21:39Z

Redirected page to Start GCode

2015-12-18T01:10:50Z

Created page with "Category:Incomplete"

New page

[[Category:Incomplete]]

@@ Line 3: / Line 3: @@
 |G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
-See also: [[Automatic G-Code]]|*G-Code
+See also: [[Automatic G-Code]]
 *[[Custom_G-Code_Variables|Custom G-Code variables]]
@@ Line 14: / Line 16: @@
 == See Also ==
-[[Automatic G-Code]]
+*[[Automatic G-Code]]

@@ Line 4: / Line 4: @@
 See also: [[Automatic G-Code]]|*G-Code
-Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|
+All G-Code must be uppercase to function properly.|
 === G-Code ===

@@ Line 1: / Line 1: @@
 {{Slice Settings
-|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.|*G-Code
+|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
 Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|

← Older revision		Revision as of 01:09, 21 January 2016
Line 8:		Line 8:

	In this example, the printer will home (G28) at the beginning of the print.}}		In this example, the printer will home (G28) at the beginning of the print.}}
		+
		+	== See Also ==
		+
		+	[[Automatic G-Code]]

← Older revision		Revision as of 21:28, 13 January 2016
Line 1:		Line 1:
−	~~#REDIRECT~~ [[~~Start_GCode~~]]	+	{{Slice Settings
		+
		+	\|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.\|*G-Code
		+
		+	Will accept [[Custom_G-Code_Variables\|Custom G-Code variables]].\|
		+
		+	=== G-Code ===
		+
		+	In this example, the printer will home (G28) at the beginning of the print.}}

← Older revision	Revision as of 20:37, 1 December 2016
(No difference)

← Older revision	Revision as of 20:56, 20 January 2016
(No difference)