SETTINGS/Printer/Extruder/Extruder X/Extruder Offset - Revision history

MatterHackers: MatterHackers moved page Settings/Printer/Extruder/Extruder X/Extruder Offset to SETTINGS/Printer/Extruder/Extruder X/Extruder Offset

2016-12-01T20:37:49Z

MatterHackers moved page Settings/Printer/Extruder/Extruder X/Extruder Offset to SETTINGS/Printer/Extruder/Extruder X/Extruder Offset

MatterHackers at 20:29, 23 November 2016

2016-11-23T20:29:09Z

Tanderson at 17:20, 20 June 2016

2016-06-20T17:20:23Z

Tanderson at 18:03, 15 June 2016

2016-06-15T18:03:07Z

MatterHackers: MatterHackers moved page Slice Settings/Printer/Extruder/Extruder X/Extruder Offset to Settings/Printer/Extruder/Extruder X/Extruder Offset without leaving a redirect

2016-01-20T20:56:15Z

MatterHackers moved page Slice Settings/Printer/Extruder/Extruder X/Extruder Offset to Settings/Printer/Extruder/Extruder X/Extruder Offset without leaving a redirect

MatterHackers: Created page with "{{Slice Settings |The X and Y coordinates of the extruder relative to the first extruder, in millimeters. Only useful for multiple extruder machines.|*millimeters (mm)| ===..."

2016-01-13T22:21:36Z

Created page with "{{Slice Settings |The X and Y coordinates of the extruder relative to the first extruder, in millimeters. Only useful for multiple extruder machines.|*millimeters (mm)| ===..."

New page

{{Slice Settings

|The X and Y coordinates of the extruder relative to the first extruder, in millimeters. Only useful for multiple extruder machines.|*millimeters (mm)|

=== mm ===

In this example, the nozzle of the second extruder is located 25 mm to the right along the X axis from the first extruder.}}

← Older revision	Revision as of 20:37, 1 December 2016
(No difference)

@@ Line 1: / Line 1: @@
 {{Slice Settings
-|Respectively, the X and Y coordinates of the extruder relative to the first extruder, in millimeters. Only useful for multiple extruder machines. Some dual extruder machines handle the offset in firmware, in which case it should be set to 0,0 in MatterControl. If the second extruder is to the right of the first, use a positive X value. If it is to the left of the first extruder, use a negative X value. Similarly, Y is positive if the second is behind the first and negative if the second is in front of the first.|*millimeters (mm)|
+|Respectively, the X and Y coordinates of the extruder relative to the first extruder, in millimeters. Only used for multiple extruder machines. Some dual extruder machines handle the offset in firmware, in which case it should be set to 0,0 in MatterControl. If the second extruder is to the right of the first, use a positive X value. If it is to the left of the first extruder, use a negative X value. Similarly, Y is positive if the second is behind the first and negative if the second is in front of the first.|*millimeters (mm)|
 === mm ===
 In this example, the nozzle of the second extruder is located 25 mm to the right along the X axis from the first extruder.}}

← Older revision	Revision as of 20:56, 20 January 2016
(No difference)