Setting Steps per mm - Revision history

MatterHackers: /* Equation */

2016-03-18T20:24:10Z

‎Equation

2016-03-18T20:23:21Z

‎Equation

2016-03-18T20:22:51Z

‎Equation

2016-02-09T23:37:27Z

2016-02-09T23:33:56Z

2016-02-03T00:36:58Z

2016-02-03T00:36:09Z

2016-01-21T01:22:09Z

2016-01-18T23:25:07Z

MatterHackers moved page Settings Steps per mm to Setting Steps per mm without leaving a redirect

2016-01-18T23:15:42Z

@@ Line 19: / Line 19: @@
 So if the current value for X was 80 and the printer only moved 97mm when trying to move 100mm, the equation would be: <code> 80 / 97 * 100</code>
-The new X Steps Per mm to 77.6
+The new X Steps Per mm to 82.47.
 The same principle applies for the extruder. If over/under-extruding, use this equation.

@@ Line 18: / Line 18: @@
 <code>New_Value = Current_Value / Actual_Distance * Desired_Distance</code>
-So if the current value for X was 80 and the printer only moved 97mm when trying to move 100mm, the equation would be: <code>97 * 80 / 100</code>
+So if the current value for X was 80 and the printer only moved 97mm when trying to move 100mm, the equation would be: <code> 80 / 97 * 100</code>
 The new X Steps Per mm to 77.6

@@ Line 16: / Line 16: @@
 Here is the equation to find the correct value:
-<code>New_Value = Actual_Distance * Current_Value / Desired_Distance</code>
+<code>New_Value = Current_Value / Actual_Distance * Desired_Distance</code>
 So if the current value for X was 80 and the printer only moved 97mm when trying to move 100mm, the equation would be: <code>97 * 80 / 100</code>

← Older revision		Revision as of 23:37, 9 February 2016
Line 1:		Line 1:
−	[[File:~~Set_eeprom1~~.png\|right\|frame\|EEPROM settings can be found under the ~~Configuration tab~~]]MatterControl can set EEProm settings for both Marlin and Repetier firmwares.	+	[[File:EEProm2.png\|right\|frame\|<center>EEPROM settings can be found under the Options menu.</center>]]MatterControl can set EEProm settings for both Marlin and Repetier firmwares.

	== Procedure ==		== Procedure ==

@@ Line 6: / Line 6: @@
 [[File:Set_eeprom2.png|none]]
-#Navigate to [[File:Settings Controls.png]]
+#Navigate to [[File:Settings Controls.png|link=Settings & Controls]]
-#Click on the [[File:Options.png]] tab
+#Click on the [[File:Options.png|link=Options]] tab
 #Connect to your printer
-#In the '''EEProm''' section click on [[File:EEProm_configure.png]]
+#In the '''EEProm''' section click on [[File:EEProm_configure.png|link=Options/EEProm]]
 #Change the '''Steps per mm''' to correct for any discrepancy you find in your movement distances. [[File:Set_eeprom5.png]]

← Older revision	Revision as of 23:25, 18 January 2016
(No difference)