Difference between revisions of "SETTINGS/Filament/Retraction/While Printing/Wipe After Retract"
From MatterControl Manual
< SETTINGS | Filament | Retraction | While Printing
(Created page with "{{Slice Settings |The extruder will wipe the nozzle over the last up to 10 mm of tool path after retracting.|*Boolean| === Boolean === The check box is checked to use the f...") |
|||
| Line 10: | Line 10: | ||
[[File:{{SUBPAGENAME}}-ss-ex1.png]] | [[File:{{SUBPAGENAME}}-ss-ex1.png]] | ||
| + | [[Category:Needs New Screenshots]] | ||
Revision as of 16:06, 30 December 2015
Function
The extruder will wipe the nozzle over the last up to 10 mm of tool path after retracting.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.
