Difference between revisions of "SETTINGS/Filament/Extrusion/Extrusion Width/Outside Perimeters"
From MatterControl Manual
< SETTINGS | Filament | Extrusion | Extrusion Width
| Line 10: | Line 10: | ||
=== mm === | === mm === | ||
| − | In this example, the adjusted nozzle diameter for the first layer extrusion will be .3 mm.}} | + | In this example, the adjusted nozzle diameter for the first layer extrusion will be 0.3 mm.}} |
=== % === | === % === | ||
Revision as of 12:03, 31 December 2015
Function
A modifier of the width of the extrusion when printing outside perimeters.
Can be useful to fine-adjust actual print size when objects print larger or smaller than specified in the digital model.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the first layer extrusion will be 0.3 mm.
%
In this example, the nozzle size set under Printer settings will be modified by 90%. For this example, the nozzle size was 0.5 mm, so the adjusted size will be 0.45 mm.
