Difference between revisions of "SETTINGS/Filament/Cooling/Cooling Thresholds/Minimum Print Speed"
From MatterControl Manual
< SETTINGS | Filament | Cooling | Cooling Thresholds
(Created page with "{{Slice Settings |The minimum speed to which the printer will reduce in order to attempt to make the layer print time long enough to satisfy the Slice Settings/Filament/Coo...") |
(No difference)
|
Revision as of 12:55, 31 December 2015
Function
The minimum speed to which the printer will reduce in order to attempt to make the layer print time long enough to satisfy the minimum layer time.
Parameters
- millimeters per second (mm/s)
Example(s)
mm/s
In this example, the printer will print at no less than 5 mm/s if required to slow down in order to attempt to satisfy the minimum layer time.
