Difference between revisions of "SETTINGS/General/Layers-Surface/Layer Height/First Layer Height"

Revision as of 12:58, 12 January 2016

A screenshot of the First Layer Height setting as seen in MatterControl's SETTINGS pane.

The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.

Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.

Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.

@@ Line 1: / Line 1: @@
 {{Slice Settings
-|Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.|*millimeters (mm)
+|The height of the first layer. A first layer taller than the default layer height can ensure good adhesion to the build plate.|*millimeters (mm)
 *percent (%)|