Difference between revisions of "SETTINGS/General/Support Material/Support Options/Infill Angle"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
(Created page with "{{Slice Settings |The angle at which the support material lines will be drawn.|*degrees Can be zero.| For this example, [http://104.154.32.252/images/7/72/Support_test.stl...") |
m (MatterHackers moved page Slice Settings/General/Support Material/Support Options/Infill Angle to Settings/General/Support Material/Support Options/Infill Angle without leaving a redirect) |
(No difference)
|
Revision as of 13:55, 20 January 2016
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.