Difference between revisions of "SETTINGS/Printer/Custom G-Code/Start G-Code"

From MatterControl Manual
Jump to: navigation, search
Line 1: Line 1:
 
{{Slice Settings
 
{{Slice Settings
  
|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.|*G-Code
+
|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
 +
 
 +
See also: [[Automatic G-Code]]|*G-Code
  
 
Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|
 
Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].|

Revision as of 16:58, 2 February 2016

A screenshot of the Start G-Code setting as seen in MatterControl's SETTINGS pane.

Function

G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.

See also: Automatic G-Code

Parameters

  • G-Code

Will accept Custom G-Code variables.

Example(s)

G-Code

In this example, the printer will home (G28) at the beginning of the print.

Start G-Code-ss-ex.png

See Also

Automatic G-Code