Difference between revisions of "SETTINGS/General/Support Material/Support Material/Amount"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Material
m (MatterHackers moved page Slice Settings/General/Support Material/Support Material/Amount to Settings/General/Support Material/Support Material/Amount without leaving a redirect) |
|||
| Line 1: | Line 1: | ||
| − | {{Slice Settings| | + | {{Deprecated|1.5|[[Settings/General/Support Material/Support Options/Support Percent|Support Percent]]}}{{Slice Settings| |
The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed {{=}} 0; parallel with the bed {{=}} 90.|*degrees | The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed {{=}} 0; parallel with the bed {{=}} 90.|*degrees | ||
Revision as of 15:49, 12 February 2016
 Deprecated: This page contains information about a feature that is no longer in use as of version 1.5. Its functionality has been upgraded or replaced with Support Percent. |
Function
The minimum angle of overhang for which support material will be created. The angle perpendicular to the bed = 0; parallel with the bed = 90.
Parameters
- degrees
Can be zero.
Presets
- Minimum : 20
- Standard : 45
- All : 90
- Custom : user-defined
Example(s)
degrees
The standard preset will generate support material for any overhang which is more than 45 degrees from perpendicular with the bed.
