Difference between revisions of "SETTINGS/General/Support Material/Support Options/Support Percent"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
(Created page with "{{Slice Settings |The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation. This replaces the Settings/General/...") |
(No difference)
|
Revision as of 12:12, 16 February 2016
Function
The percentage of extrusion width that overlaps on the previous layer which will trigger support material generation.
This replaces the Amount setting which was deprecated in version 1.5.
Parameters
- percent (%)
Presets
- Little : 10%
- Standard : 50%
- Lots : 90%
- Custom : user-defined
Example(s)
percent
In this example, a layer with an extrusion width which hangs 50% off over the previous layer will have support material generated.
