Difference between revisions of "SETTINGS/Filament/Retraction/While Printing/Extra Length On Restart"

From MatterControl Manual
Jump to: navigation, search
Line 1: Line 1:
 
{{Slice Settings
 
{{Slice Settings
  
|Length of filament to extrude after a complete retraction (in addition to the re-extrusion of the [[Settings/Filament/Filament/Retraction/Length on Move|Length on Move]] distance).|*millimeters (mm)
+
|Length of filament to extrude after a complete retraction (in addition to the re-extrusion of the [[Settings/Filament/Retraction/While Printing/Length on Move|Length on Move]] distance).|*millimeters (mm)
  
 
Can be zero.
 
Can be zero.

Revision as of 12:55, 21 November 2016

A screenshot of the Extra Length On Restart setting as seen in MatterControl's SETTINGS pane.

Function

Length of filament to extrude after a complete retraction (in addition to the re-extrusion of the Length on Move distance).

Parameters

  • millimeters (mm)

Can be zero.

Can be negative.

Example(s)

mm

In this example, an additional 0.1 mm will be extruded after retraction.

Extra Length On Restart-ss-ex.png