Difference between revisions of "SETTINGS/General/Speed/Speed for Infill"
From MatterControl Manual
m (MatterHackers moved page Settings/General/Speed/Speed for Infill to SETTINGS/General/Speed/Speed for Infill) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{Slice Settings Subsection|the speed at which infill | + | {{Slice Settings Subsection|the speed at which infill will print.}} |
Latest revision as of 12:37, 1 December 2016
Speed for Infill is a section of the Speed sub-category in General settings which deals with the speed at which infill will print.
Settings:
