Difference between revisions of "SETTINGS/Printer/Print Leveling/Probe Settings/Z Offset"

Revision as of 12:37, 1 December 2016

A screenshot of the Z Offset setting as seen in MatterControl's SETTINGS pane.

The thickness of the paper (or other calibration device) used to perform manual bed probe.

In this example, the paper to be used during the manual bed probe is 0.1 mm thick.

Revision as of 12:56, 20 January 2016 (view source) MatterHackers (Talk \| contribs) m (MatterHackers moved page Slice Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width without leaving a redirect) ← Older edit	Revision as of 12:37, 1 December 2016 (view source) MatterHackers (Talk \| contribs) m (MatterHackers moved page Settings/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width to SETTINGS/Printer/Print Leveling/Probe Settings/Manual Probe Paper Width) Newer edit →
(No difference)