Difference between revisions of "SETTINGS/General"
From MatterControl Manual
< SETTINGS
m (MatterHackers moved page Slice Settings/General to Settings/General without leaving a redirect) |
|||
(5 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | __NOTOC__{{DISPLAYTITLE:General}}[[File:ss-{{SUBPAGENAME}}-ss.png|right|framed|<center>The '{{SUBPAGENAME}}' category of slice settings as seen in the MatterControl settings pane.</center>]]Slice Settings found under this category apply to how the prints look and are physically formed. | + | __NOTOC__{{DISPLAYTITLE:General}}[[File:ss-{{SUBPAGENAME}}-ss.png|right|framed|<center>The '''{{SUBPAGENAME}}''' category of slice settings as seen in the MatterControl settings pane.</center>]]Slice Settings found under this category apply to how the prints look and are physically formed. |
− | == | + | == Sections == |
− | === [[ | + | === [[SETTINGS/General/Layers-Surface|Layers / Surface]] === |
− | === [[ | + | === [[SETTINGS/General/Infill|Infill]] === |
− | === [[ | + | === [[SETTINGS/General/Speed|Speed]] === |
− | === [[ | + | === [[SETTINGS/General/Raft-Priming|Raft / Priming]] === |
− | === [[ | + | === [[SETTINGS/General/Support Material|Support Material]] === |
− | === [[ | + | === [[SETTINGS/General/Output Options|Output Options]] === |
− | === [[ | + | === [[SETTINGS/General/Multiple Extruders|Multiple Extruders]] === |
+ | === [[SETTINGS/General/Single Print|Single Print]] === |