Difference between revisions of "SETTINGS/General/Speed"
From MatterControl Manual
(Created page with "{{Slice Settings Category|the speed at which specific parts of the print are printed.}} == Sub-sections == === Speed for Infill === <DynamicPageList> category =...") |
|||
| (11 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{Slice Settings Category|the speed at which specific | + | {{Slice Settings Category|the speed at which specific sections of the model will print.}} |
| − | == | + | == Sections == |
| − | === Speed for Infill === | + | === [[SETTINGS/General/Speed/Speed_for_Infill|Speed for Infill]] === |
| − | < | + | <splist parent = SETTINGS/General/Speed/Speed_for_Infill /> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | === [[SETTINGS/General/Speed/Speed_for_Perimeters|Speed for Perimeters]] === | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | < | + | <splist parent = SETTINGS/General/Speed/Speed_for_Perimeters /> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | < | + | === [[SETTINGS/General/Speed/Speed_for_Other_Printing|Speed for Other Printing]] === |
| − | + | ||
| − | + | <splist parent = SETTINGS/General/Speed/Speed_for_Other_Printing /> | |
| − | + | ||
| − | + | === [[SETTINGS/General/Speed/Speed_for_Non-Print_Moves|Speed for Non-Print Moves]] === | |
| − | </ | + | |
| + | <splist parent = SETTINGS/General/Speed/Speed_for_Non-Print_Moves /> | ||
| + | |||
| + | === [[SETTINGS/General/Speed/Modifiers|Modifiers]] === | ||
| + | |||
| + | <splist parent = SETTINGS/General/Speed/Modifiers /> | ||
Latest revision as of 12:41, 1 December 2016
Speed is a sub-category of General settings which deal with the speed at which specific sections of the model will print.
