Difference between revisions of "SETTINGS/Printer/Print Recovery/Recover Settings/Enable Recovery"
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
m (MatterHackers moved page Settings/Printer/Print Recovery/Recover Settings/Enable Recovery to SETTINGS/Printer/Print Recovery/Recover Settings/Enable Recovery) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power.|*Boolean| | + | |If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power. |
| + | |||
| + | === Restrictions === | ||
| + | |||
| + | *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print.|*Boolean| | ||
=== Boolean === | === Boolean === | ||
Latest revision as of 17:31, 6 December 2016
Function
If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power.
Restrictions
- This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.
