Difference between revisions of "SETTINGS/Printer/Print Recovery/Recover Settings/Recover Layer Speed"
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
| Line 3: | Line 3: | ||
|The speed at which the nozzle will move when recovering a failed print, for one layer. | |The speed at which the nozzle will move when recovering a failed print, for one layer. | ||
| − | + | === Restrictions === | |
| + | |||
| + | *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print.|*millimeters per second (mm/s)| | ||
=== mm/s === | === mm/s === | ||
In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.}} | In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.}} | ||
Latest revision as of 17:32, 6 December 2016
Function
The speed at which the nozzle will move when recovering a failed print, for one layer.
Restrictions
- This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Parameters
- millimeters per second (mm/s)
Example(s)
mm/s
In this example the nozzle will move at 10 mm/s whilst printing the layer the printer was on when it failed.
