Difference between revisions of "SETTINGS/General/Infill"
From MatterControl Manual
(Created page with "__NOTOC__ {{Slice Settings Category|how the inside(s) of the model are filled.}} == Sub-sections == === Infill === <DynamicPageList> category = Infill ordermeth...") |
|||
| (12 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{Slice Settings Category|how the inside(s) of the model will print.}} | |
| − | {{Slice Settings Category|how the inside(s) of the model | + | |
| − | == | + | == Sections == |
| − | === Infill === | + | === [[SETTINGS/General/Infill/Infill|Infill]] === |
| − | < | + | <splist parent = SETTINGS/General/Infill/Infill /> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | === [[SETTINGS/General/Infill/Advanced|Advanced]] === | |
| − | + | ||
| − | + | <splist parent = SETTINGS/General/Infill/Advanced /> | |
| − | + | ||
| − | + | ||
| − | </ | + | |
Latest revision as of 11:00, 22 December 2016
Infill is a sub-category of General settings which deal with how the inside(s) of the model will print.
