Difference between revisions of "SETTINGS/Printer/Print Leveling/Machine Settings/Leveling Positions"
From MatterControl Manual
< SETTINGS | Printer | Print Leveling | Machine Settings
(Created page with "{{Slice Settings |If set, these positions will be used when running the leveling solution. Leave empty for defaults. === Data Format === X1,Y1:X2,Y2:...:Xn,Yn |*List of X...") |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 2: | Line 2: | ||
|If set, these positions will be used when running the leveling solution. Leave empty for defaults. | |If set, these positions will be used when running the leveling solution. Leave empty for defaults. | ||
| + | |||
| + | This setting is only available if you have chosen either 3 Point Plane or 3x3 Mesh for your leveling solution.|*X and Y coordinates | ||
=== Data Format === | === Data Format === | ||
| − | X1,Y1:X2,Y2: | + | ==== 3 Point Plane ==== |
| + | |||
| + | X1,Y1:X2,Y2:X3,Y3 | ||
| − | + | ==== 3x3 Mesh ==== | |
| − | }} | + | X1,Y1:X2,Y2:X3,Y3:X4,Y4:X5,Y5:X6,Y6:X7,Y7:X8,Y8:X9,Y9|In this example, the SPL wizard will run using the 3 Point Plane configuration at the points 4,7; 200,12; and 100,220}} |
Latest revision as of 14:46, 1 August 2017
Function
If set, these positions will be used when running the leveling solution. Leave empty for defaults.
This setting is only available if you have chosen either 3 Point Plane or 3x3 Mesh for your leveling solution.
Parameters
- X and Y coordinates
Data Format
3 Point Plane
X1,Y1:X2,Y2:X3,Y3
3x3 Mesh
X1,Y1:X2,Y2:X3,Y3:X4,Y4:X5,Y5:X6,Y6:X7,Y7:X8,Y8:X9,Y9
Example(s)
In this example, the SPL wizard will run using the 3 Point Plane configuration at the points 4,7; 200,12; and 100,220
