Difference between revisions of "SETTINGS/Printer/Custom G-Code/Write Filters"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
| Line 7: | Line 7: | ||
=== Data Format === | === Data Format === | ||
| − | *Command to | + | Example variables: |
| + | |||
| + | *Command to be replaced: C | ||
*Replacement command: R | *Replacement command: R | ||
"^(C)","R"|In this example, the command 'G28' is replaced with 'G28,M280 P0 S160,G4...'.}} | "^(C)","R"|In this example, the command 'G28' is replaced with 'G28,M280 P0 S160,G4...'.}} | ||
Revision as of 09:32, 2 August 2017
Function
A set of regular expressions to apply to lines prior to sending to a printer. They will be applied in the order listed before sending. To return more than one instruction separate them with a comma.
Used to replace G-Code commands with other commands.
Parameters
- Regular Expressions
Data Format
Example variables:
- Command to be replaced: C
- Replacement command: R
"^(C)","R"
Example(s)
In this example, the command 'G28' is replaced with 'G28,M280 P0 S160,G4...'.
