Difference between revisions of "CONTROLS/Fan"
From MatterControl Manual
< CONTROLS
| (3 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|printer-controls/index#Fan}} | ||
{{DISPLAYTITLE:Fan}} | {{DISPLAYTITLE:Fan}} | ||
| Line 6: | Line 7: | ||
[[File:Fan Controls-100-ss.png|none|framed|<center>The fan is on at full power.</center>]] | [[File:Fan Controls-100-ss.png|none|framed|<center>The fan is on at full power.</center>]] | ||
| + | |||
| + | [[File:Fan Controls-Set-ss.png|none|framed|<center>Enter a value and click the '''SET''' button.</center>]] | ||
[[File:Fan Controls-37-ss.png|none|framed|<center>The fan is on at 37% of full power.</center>]] | [[File:Fan Controls-37-ss.png|none|framed|<center>The fan is on at 37% of full power.</center>]] | ||
[[Category:Controls]] | [[Category:Controls]] | ||
| + | [[Category:Features]] | ||
Latest revision as of 10:54, 4 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
The slider allows for the specification of power to the layer-cooling fan(s), expressed as a percentage. 0% is off, 100% is full power. Can be any value from 0-100.
