Difference between revisions of "SETTINGS/General/Infill/Infill/Fill Density"
From MatterControl Manual
| (3 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/general#fill-density}} | ||
{{Slice Settings | {{Slice Settings | ||
| Line 11: | Line 12: | ||
*Standard : 30% | *Standard : 30% | ||
*Heavy : 90% | *Heavy : 90% | ||
| − | *Custom : user-defined (can be % or ratio)| | + | *Custom : user-defined (can be % or ratio)|[[File:Infill.jpg|roight|frame|<center>A basic cube using [[CuraEngine|Cura]]'s infill pattern at 10%.</center>]] |
=== % === | === % === | ||
Latest revision as of 11:36, 5 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The amount of infill material to generate, expressed as a mathematical term-- specifically, ratio or a percentage.
Parameters
- percent (%)
- ratio
Can be zero.
Presets
- Light : 10%
- Standard : 30%
- Heavy : 90%
- Custom : user-defined (can be % or ratio)
Example(s)
%
Using a percentage. In this case, the infill will be 37% of the total area designated for infill.
ratio
Using a ratio from 0 to 1. In this case, 0.89 translates to 89%. Actual infill will be 89% of the total area designated for infill.
