Difference between revisions of "SETTINGS/General/Speed/Speed for Infill/Infill"
From MatterControl Manual
< SETTINGS | General | Speed | Speed for Infill
| (6 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/speed/speed#infill}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The speed at which infill | + | |The speed at which infill will print.|*millimeters per second (mm/s) |
| + | |||
| + | == [[Custom G-Code Variables|Custom G-Code Variable]] == | ||
| + | |||
| + | <code>infill_speed</code>| | ||
=== mm/s === | === mm/s === | ||
In the case shown below, the infill will print at 40 mm/s.}} | In the case shown below, the infill will print at 40 mm/s.}} | ||
Latest revision as of 13:06, 12 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The speed at which infill will print.
Parameters
- millimeters per second (mm/s)
Custom G-Code Variable
infill_speed
Example(s)
mm/s
In the case shown below, the infill will print at 40 mm/s.
