Difference between revisions of "SETTINGS/General/Speed/Speed for Infill/Raft"
From MatterControl Manual
< SETTINGS | General | Speed | Speed for Infill
| (6 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/speed/speed#raft}} | ||
{{Slice Settings | {{Slice Settings | ||
|The speed at which the layers of the raft (other than the first layer) will print.|*millimeters per second (mm/s) | |The speed at which the layers of the raft (other than the first layer) will print.|*millimeters per second (mm/s) | ||
| − | * | + | *percent [of [[Settings/General/Speed/Speed_for_Infill/Infill|Infill speed]]] (%) |
| + | |||
| + | == [[Custom G-Code Variables|Custom G-Code Variable]] == | ||
| + | |||
| + | <code>raft_print_speed</code>| | ||
=== mm/s === | === mm/s === | ||
Latest revision as of 15:23, 12 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The speed at which the layers of the raft (other than the first layer) will print.
Parameters
- millimeters per second (mm/s)
- percent [of Infill speed] (%)
Custom G-Code Variable
raft_print_speed
Example(s)
mm/s
In this example, the raft infill will print at 35 mm/s.
%
In this example, the raft infill will print at 75% of the Infill speed (which if you can make out the blurred text is set at 40), so the final result will be 30 mm/s.
