Difference between revisions of "SETTINGS/General/Raft-Priming/Raft/Air Gap"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Raft
(Created page with "{{Slice Settings |The distance between the first layer and the top of the raft. A good value is typically about half the Slice Settings/Printer/Extruder/Extruder X/Nozzle D...") |
|||
| (4 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/adhesion/raft#air-gap}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The distance between the first layer and the top of the raft. A good value is typically about half the [[ | + | |The distance between the first layer and the top of the raft. A good value is typically about half the [[Settings/Printer/Extruder/Extruder X/Nozzle Diameter|extrusion diameter]]. For a 0.4 mm nozzle, a value between 0.0 and 0.2 would be best.|*millimeters (mm)| |
=== mm === | === mm === | ||
In this example, a 0.2 mm gap will be left between the raft and the first layer.}} | In this example, a 0.2 mm gap will be left between the raft and the first layer.}} | ||
Latest revision as of 14:40, 17 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The distance between the first layer and the top of the raft. A good value is typically about half the extrusion diameter. For a 0.4 mm nozzle, a value between 0.0 and 0.2 would be best.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, a 0.2 mm gap will be left between the raft and the first layer.
