Difference between revisions of "SETTINGS/General/Single Print/Settings Will Clear at End of Print/Bottom Clip"
From MatterControl Manual
(Created page with "{{Slice Settings |The amount to remove from the bottom of the model, in millimeters. Useful for printing portions of a larger print that failed at a certain height so the tw...") |
(No difference)
|
Revision as of 14:42, 17 December 2015
Function
The amount to remove from the bottom of the model, in millimeters.
Useful for printing portions of a larger print that failed at a certain height so the two pieces can be glued together.
Parameters
mm
Can be zero.
Example(s)
mm
Specify the amount of the model to remove from slicing, in millimeters. In this example, the bottom 10 mm of the model will not be sliced, and the first layer will start at the layer just above the 10 mm mark.
