Difference between revisions of "SETTINGS/General/Speed/Speed for Infill/Raft"
From MatterControl Manual
< SETTINGS | General | Speed | Speed for Infill
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The speed at which the layers of the raft (other than the first layer) | + | |The speed at which the layers of the raft (other than the first layer) will be printed.|Millimeters per second or percentage [of [[Slice_Settings/General/Speed/Speed_for_Infill/Infill|Infill speed]]]| |
=== mm/s === | === mm/s === | ||
Revision as of 16:35, 18 December 2015
Function
The speed at which the layers of the raft (other than the first layer) will be printed.
Parameters
Millimeters per second or percentage [of Infill speed]
Example(s)
mm/s
In this example, the raft infill will print at 35 mm/s.
%
In this example, the raft infill will print at 75% of the Infill speed (which if you can make out the blurred text is set at 40), so the final result will be 30 mm/s.
