Difference between revisions of "SETTINGS/General/Speed/Modifiers/First Layer Speed"
From MatterControl Manual
(Created page with "{{Slice Settings |The speed at which the nozzle will move when printing the first layer. If expressed as a percentage the Infill speed is modified.|*millimeters per second (m...") |
(No difference)
|
Revision as of 16:09, 21 December 2015
Function
The speed at which the nozzle will move when printing the first layer. If expressed as a percentage the Infill speed is modified.
Parameters
- millimeters per second (mm/s)
- percentage [of Infill] (%)
Example(s)
mm/s
In this example, the first layer will print at 20 mm/s.
%
In this example, the first layer will print at 35% percent of the Infill speed (which for this example is set at 40), so the final speed will be 14 mm/s.