Difference between revisions of "SETTINGS/General/Layers-Surface/Layer Height/First Layer Height"
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Layer Height
Line 10: | Line 10: | ||
=== % === | === % === | ||
− | Must enter '%' after input to activate. Used to specify height of first layer relative to [[Layer Height]] as a percentage. | + | Must enter '%' after input to activate. Used to specify height of first layer relative to [[Slice Settings/General/Layers-Surface/Layer Height/Layer Height|Layer Height]] as a percentage. |
[[File:{{SUBPAGENAME}}-ss-ex1.png]] | [[File:{{SUBPAGENAME}}-ss-ex1.png]] |
Revision as of 16:51, 21 December 2015
Function
Sets the height of the first layer. It is often desirable to print a taller first layer to ensure a good solid adhesion to the build plate.
Parameters
- millimeters (mm)
- percent (%)
Example(s)
mm
Used as the default if no parameter type is specified. Will create a first layer of the specified millimeters thick.
%
Must enter '%' after input to activate. Used to specify height of first layer relative to Layer Height as a percentage.