Difference between revisions of "SETTINGS/General/Raft-Priming/Raft/Fan Speed"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Raft
(Created page with "{{Slice Settings |The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage.|*percent (%) While the value can be any whole nu...") |
(No difference)
|
Revision as of 16:57, 21 December 2015
Function
The speed at which the cooling fan(s) will run during the printing of the raft, expressed as a percentage.
Parameters
- percent (%)
While the value can be any whole number from 0-100, the following values will produce these effects:
0% : off
50% : half speed
100% : full speed
Example(s)
%
At 100% the cooling fan(s) will be on at full blast during the printing of the raft.
