Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"
| (8 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/adhesion/skirt#minimum-extrusion-length}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The minimum length of filament to use | + | |The minimum length of filament to use to draw the [[SETTINGS/General/Raft-Priming/Priming/Loops|priming loops]]. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value. This is the measurement of the filament going into the extruder, not the length of the loops being extruded. We recommend setting this to the length of your hot end's hot zone. For an E3D or similar hot end this will be about 15 mm|*millimeters (mm) |
Can be zero.| | Can be zero.| | ||
Latest revision as of 11:10, 14 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The minimum length of filament to use to draw the priming loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value. This is the measurement of the filament going into the extruder, not the length of the loops being extruded. We recommend setting this to the length of your hot end's hot zone. For an E3D or similar hot end this will be about 15 mm
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
