Difference between revisions of "CONTROLS/Tuning Adjustment"
| (8 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{DISPLAYTITLE:Tuning Adjustment}} | + | {{Migrated|printer-controls/index#tuning-adjustment}} |
| + | {{DISPLAYTITLE:Tuning Adjustment}}__NOTOC__[[File:Tuning Adjustment-ss.png|right|framed|<center>The '''Tuning Adjustment''' section of the Controls pane.</center>]]The Tuning Adjustment section of the Controls pane allows the user to change the speed and extrusion values during an active print. | ||
| − | + | Use the slider or enter a value and click '''Set'''. | |
| − | + | ||
| − | Use the slider or enter a value and click ''' | + | |
== Speed Multiplier == | == Speed Multiplier == | ||
| − | When used during an active print, the speed multiplier modifies the speeds as set under the [[ | + | When used during an active print, the speed multiplier modifies the speeds as set under the [[Settings/General/Speed|Speed section in General settings]] by multiplying itself times each setting. |
=== Range === | === Range === | ||
| Line 18: | Line 17: | ||
When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the [[#Formula|formula below]]). | When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the [[#Formula|formula below]]). | ||
| − | This variable is different from that of the [[ | + | This variable is different from that of the [[Settings/Filament/Extrusion/Flow/Extrusion Multiplier|Extrusion Multiplier slice setting]] and will work in conjunction with it. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08). |
=== Formula === | === Formula === | ||
| Line 30: | Line 29: | ||
[[Category:Controls]] | [[Category:Controls]] | ||
| + | [[Category:Features]] | ||
Latest revision as of 10:50, 4 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Use the slider or enter a value and click Set.
Speed Multiplier
When used during an active print, the speed multiplier modifies the speeds as set under the Speed section in General settings by multiplying itself times each setting.
Range
- Low : 0.5
- High : 2.0
Extrusion Multiplier
When used during an active print, the extrusion multiplier modifies the extrusion flow rate (as defined in the formula below).
This variable is different from that of the Extrusion Multiplier slice setting and will work in conjunction with it. For example, if the slicer setting is set at 1.06 and then the slider in Controls is used during the print and set to 1.08, the total result will be a multiplier of 1.1448 (1.06 * 1.08).
Formula
The general extrusion flow formula: layer height / (filament area (pi*r²) * extrusion multiplier)
Range
- Low : 0.5
- High : 3.0
