Difference between revisions of "SETTINGS/General/Support Material/Support Options/Infill Angle"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
m (MatterHackers moved page Slice Settings/General/Support Material/Support Options/Infill Angle to Settings/General/Support Material/Support Options/Infill Angle without leaving a redirect) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/support/advanced#infill-angle}} | ||
{{Slice Settings | {{Slice Settings | ||
Latest revision as of 12:20, 31 December 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.
