Difference between revisions of "SETTINGS/Filament/Retraction/While Printing/Extra Length On Restart"
From MatterControl Manual
< SETTINGS | Filament | Retraction | While Printing
m (Text replacement - "[[Slice Settings/" to "[[Settings/") |
|||
| (6 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/filament/retraction#extra-length-on-restart}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | | | + | |Maximum length of filament to extrude after a complete retraction (in addition to the re-extrusion of the [[Settings/Filament/Retraction/While Printing/Length on Move|Length on Move]] distance). |
| + | |||
| + | Limited by the [[SETTINGS/Filament/Retraction/While_Printing/Time_For_Extra_Length|Time For Extra Length]] setting.|*millimeters (mm) | ||
Can be zero. | Can be zero. | ||
| Line 9: | Line 12: | ||
=== mm === | === mm === | ||
| − | In this example, an additional 0. | + | In this example, an additional 0.5 mm will be extruded after retraction.}} |
Latest revision as of 17:50, 8 April 2019
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
Maximum length of filament to extrude after a complete retraction (in addition to the re-extrusion of the Length on Move distance).
Limited by the Time For Extra Length setting.
Parameters
- millimeters (mm)
Can be zero.
Can be negative.
Example(s)
mm
In this example, an additional 0.5 mm will be extruded after retraction.
