Difference between revisions of "SETTINGS/Filament/Retraction"
From MatterControl Manual
| (3 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
== Sub-sections == | == Sub-sections == | ||
| − | === [[ | + | === [[SETTINGS/Filament/Retraction/While_Printing|While Printing]] === |
| − | <splist parent = | + | <splist parent = SETTINGS/Filament/Retraction/While_Printing /> |
| − | === [[ | + | === [[SETTINGS/Filament/Retraction/On_Tool_Change|On Tool Change]] === |
| − | <splist parent = | + | <splist parent = SETTINGS/Filament/Retraction/On_Tool_Change /> |
Latest revision as of 12:52, 1 December 2016
Retraction is a sub-category of Filament settings which deal with filament the print will use.
