Difference between revisions of "SETTINGS/Printer/Print Recovery/Recover Settings/Enable Recovery"
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
(Created page with "{{Slice Settings |Function text|*parameters text| === Parameter 1 === Caption for Example for Parameter 1.}} === Parameter 2 === Caption for example for Parameter 2. F...") |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
− | | | + | |If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power. |
− | === | + | === Restrictions === |
− | + | *This section (Print Recovery) is not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print.|*Boolean| | |
− | === | + | === Boolean === |
− | + | The check box is checked to use the function.}} | |
− | + | The check box is unchecked to leave the function unused. | |
− | [[ | + | [[File:{{SUBPAGENAME}}-ss-ex1.png]] |
Latest revision as of 17:31, 6 December 2016
Function
If enabled, MatterControl will attempt to recover a print in the event of a failure such as broken connection or loss of power.
Restrictions
- This section (Print Recovery) is not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Parameters
- Boolean
Example(s)
Boolean
The check box is checked to use the function.
The check box is unchecked to leave the function unused.