Difference between revisions of "SETTINGS/General/Layers-Surface/Outer Surface - Perimeters/Start End Overlap"
< SETTINGS | General | Layers-Surface | Outer Surface - Perimeters| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/layers-surface#start-end-overlap}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The distance that | + | |The distance that a perimeter will overlap itself when it completes its loop, expressed as a percentage of the [[Settings/Printer/Extruder/Extruder X/Nozzle Diameter|Nozzle Diameter]].|*percent| |
=== percent === | === percent === | ||
This diagram illustrates how Start End Overlap works:}} | This diagram illustrates how Start End Overlap works:}} | ||
Latest revision as of 15:19, 6 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The distance that a perimeter will overlap itself when it completes its loop, expressed as a percentage of the Nozzle Diameter.
Parameters
- percent
Example(s)
percent
This diagram illustrates how Start End Overlap works:
