|
|
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | [[File:Infill.jpg|center|frame|A basic cube using [http://wiki.mattercontrol.com/CuraEngine Cura]'s infill pattern at 10%.]] | + | #REDIRECT [[Slice Settings/General/Infill]] |
| − | | + | |
| − | '''Infill''' is the material used to fill the space between the horizontal layers of a print. It can be assigned a percentage value from 0 to 100%, which changes the density of the material. It is used to increase structural integrity, and can also serve to add weight to a part. Depending on your [[Slice Engines|Slice Engine]], the infill pattern can be changed to suit your needs.
| + | |
| − | | + | |
| − | [[Category:Slice Settings]]
| + | |