Difference between revisions of "SETTINGS/General"
From MatterControl Manual
< SETTINGS
(Created page with "Slice Settings found under this category apply to how the prints look and are physically formed.") |
|||
| (13 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Slice Settings found under this category apply to how the prints look and are physically formed. | + | __NOTOC__{{DISPLAYTITLE:General}}[[File:ss-{{SUBPAGENAME}}-ss.png|right|framed|<center>The '''{{SUBPAGENAME}}''' category of slice settings as seen in the MatterControl settings pane.</center>]]Slice Settings found under this category apply to how the prints look and are physically formed. |
| + | |||
| + | == Sections == | ||
| + | |||
| + | === [[SETTINGS/General/Layers-Surface|Layers / Surface]] === | ||
| + | === [[SETTINGS/General/Infill|Infill]] === | ||
| + | === [[SETTINGS/General/Speed|Speed]] === | ||
| + | === [[SETTINGS/General/Raft-Priming|Raft / Priming]] === | ||
| + | === [[SETTINGS/General/Support Material|Support Material]] === | ||
| + | === [[SETTINGS/General/Output Options|Output Options]] === | ||
| + | === [[SETTINGS/General/Multiple Extruders|Multiple Extruders]] === | ||
| + | === [[SETTINGS/General/Single Print|Single Print]] === | ||
Latest revision as of 12:38, 1 December 2016
