Difference between revisions of "SETTINGS/Filament/Retraction"
From MatterControl Manual
(Created page with "{{Slice Settings Category|the speed at which specific parts of the print are printed.}} == Sub-sections == === Filament === <DynamicPageList> category = Filamen...") |
|||
| (15 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{Slice Settings Category| | + | {{Slice Settings Category|filament the print will use.}} |
== Sub-sections == | == Sub-sections == | ||
| − | === Filament === | + | === [[SETTINGS/Filament/Retraction/While_Printing|While Printing]] === |
| − | < | + | <splist parent = SETTINGS/Filament/Retraction/While_Printing /> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | === [[SETTINGS/Filament/Retraction/On_Tool_Change|On Tool Change]] === | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | < | + | <splist parent = SETTINGS/Filament/Retraction/On_Tool_Change /> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
Latest revision as of 12:52, 1 December 2016
Retraction is a sub-category of Filament settings which deal with filament the print will use.
