Difference between revisions of "SETTINGS/General/Layers-Surface/Outer Surface - Perimeters/Perimeters"
From MatterControl Manual
< SETTINGS | General | Layers-Surface | Outer Surface - Perimeters
(Created page with "{{Slice Settings |The number, or total width, of external shells to create. Add mm to the end of the number to specify width in millimeters.|Count or millimeters| === count...") |
|||
| (3 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/general#perimeters}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The number, or total width, of external shells to create. Add mm to the end of the number to specify width in millimeters.| | + | |The number, or total width, of external shells to create. Add mm to the end of the number to specify width in millimeters.|*count |
| + | *millimeters (mm)| | ||
=== count === | === count === | ||
Latest revision as of 10:30, 5 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The number, or total width, of external shells to create. Add mm to the end of the number to specify width in millimeters.
Parameters
- count
- millimeters (mm)
Example(s)
count
Seen here in 2D Layer View, the first layer of this cube model has a perimeter count of 5. The red box highlights the five perimeters on the left side of the cube.
mm
Seen here in 2D Layer View, the first layer of this cube model has a 3mm perimeter.
