Difference between revisions of "SETTINGS/General/Infill/Advanced/Infill Overlap"
From MatterControl Manual
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/infill#infill-overlap}} | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.| | + | |The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.|*millimeters (mm) |
Can be zero.| | Can be zero.| | ||
Latest revision as of 11:07, 12 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
On the right half of this screenshot, the three lines on the left are the perimeters, and the diagonal lines on the right are the infill. The infill overlaps just 0.06 mm, which is usually enough to ensure that the infill will stick to the inside-most perimeter.
