Difference between revisions of "SETTINGS/General/Support Material/Support Options/Infill Angle"
From MatterControl Manual
< SETTINGS | General | Support Material | Support Options
(Created page with "{{Slice Settings |The angle at which the support material lines will be drawn.|*degrees Can be zero.| For this example, [http://104.154.32.252/images/7/72/Support_test.stl...") |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/support/advanced#infill-angle}} | ||
{{Slice Settings | {{Slice Settings | ||
Latest revision as of 12:20, 31 December 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The angle at which the support material lines will be drawn.
Parameters
- degrees
Can be zero.
Example(s)
For this example, Support_test.stl is the model used.
degrees
In this example, the infill angle is 60 degrees as shown on the first layer of the model in 2D Layer View.
