Difference between revisions of "SETTINGS/Filament/Retraction/While Printing/Extra Length On Restart"
From MatterControl Manual
< SETTINGS | Filament | Retraction | While Printing
(Created page with "{{Slice Settings |Additional distance of filament to extrude after a retraction.|*millimeters (mm) Can be zero. Can be negative.| === mm === In this example, an additiona...") |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | | | + | |Distance of filament to extrude after a retraction (in addition to the un-retraction of [[Slice Settings/Filament/Filament/Retraction/Length on Move|Length on Move]]).|*millimeters (mm) |
Can be zero. | Can be zero. | ||
Revision as of 14:56, 12 January 2016
Function
Distance of filament to extrude after a retraction (in addition to the un-retraction of Length on Move).
Parameters
- millimeters (mm)
Can be zero.
Can be negative.
Example(s)
mm
In this example, an additional 0.1 mm will be extruded after retraction.
