Difference between revisions of "SETTINGS/Filament/Extrusion/Extrusion Width/First Layer"
From MatterControl Manual
< SETTINGS | Filament | Extrusion | Extrusion Width
(Created page with "{{Slice Settings |A modifier of the width of the extrusion for the first layer of the print. A value greater th...") |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |A modifier of the [[Slice Settings/Printer/Extruder/Extruder X/Nozzle Diameter|width of the extrusion]] for the first layer of the print. A value greater than 100% can help with adhesion to the print bed.|*millimeters (mm) | + | |A modifier of the [[Slice Settings/Printer/Extruder/Extruder X/Nozzle Diameter|width of the extrusion]] for the first layer of the print. |
| + | |||
| + | A value greater than 100% can help with adhesion to the print bed.|*millimeters (mm) | ||
*percent (%) | *percent (%) | ||
| Line 12: | Line 14: | ||
=== % === | === % === | ||
| − | In this example, the [[Slice Settings/Printer/Extruder/Extruder X/Nozzle Diameter|nozzle | + | In this example, the [[Slice Settings/Printer/Extruder/Extruder X/Nozzle Diameter|nozzle diameter set under Printer settings]] will be modified by 110%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.44 mm. |
[[File:{{SUBPAGENAME}}-ss-ex1.png]] | [[File:{{SUBPAGENAME}}-ss-ex1.png]] | ||
Revision as of 11:50, 31 December 2015
Function
A modifier of the width of the extrusion for the first layer of the print.
A value greater than 100% can help with adhesion to the print bed.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the first layer extrusion will be .5 mm.
%
In this example, the nozzle diameter set under Printer settings will be modified by 110%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.44 mm.
